decimal3d:instructions_for_use:instructions_for_use
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| decimal3d:instructions_for_use:instructions_for_use [2019/09/04 13:33] – kerhart | decimal3d:instructions_for_use:instructions_for_use [2019/09/04 13:34] – kerhart | ||
|---|---|---|---|
| Line 60: | Line 60: | ||
| ==== Known Limitations ==== | ==== Known Limitations ==== | ||
| - | Below are listed the known application limitations, | + | Below are listed the known application limitations, |
| - | + | ||
| - | === General === | + | |
| - Treatment position information (e.g. isocenter, gantry angle, couch angle, collimator angle) is not available at this time as there is no sufficient link between the scanner coordinate and treatment machine coordinate systems | - Treatment position information (e.g. isocenter, gantry angle, couch angle, collimator angle) is not available at this time as there is no sufficient link between the scanner coordinate and treatment machine coordinate systems | ||
decimal3d/instructions_for_use/instructions_for_use.txt · Last modified: 2023/04/17 16:34 by kerhart