decimal3d:instructions_for_use:instructions_for_use
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| decimal3d:instructions_for_use:instructions_for_use [2019/09/13 01:38] – [Known Limitations] kerhart | decimal3d:instructions_for_use:instructions_for_use [2019/10/16 17:44] – kmobile | ||
|---|---|---|---|
| Line 73: | Line 73: | ||
| - Once a beam has been created its name cannot be edited (beam names are used within the cutout engraving, therefore if an appropriate name was used, we recommend that you create a new beam with the desired name, using the same parameters, and then delete the wrongly named beam) | - Once a beam has been created its name cannot be edited (beam names are used within the cutout engraving, therefore if an appropriate name was used, we recommend that you create a new beam with the desired name, using the same parameters, and then delete the wrongly named beam) | ||
| + | [[decimal3d: | ||
| ===== Release Notes ===== | ===== Release Notes ===== | ||
decimal3d/instructions_for_use/instructions_for_use.txt · Last modified: 2023/04/17 16:34 by kerhart