decimal3d:instructions_for_use:instructions_for_use
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
decimal3d:instructions_for_use:instructions_for_use [2019/11/21 14:20] – [Overview, Indications for Use, and Intended Use] kerhart | decimal3d:instructions_for_use:instructions_for_use [2019/11/29 13:03] – [Clinical Safety] kerhart | ||
---|---|---|---|
Line 13: | Line 13: | ||
===== Clinical Safety ===== | ===== Clinical Safety ===== | ||
- | It is the responsibility | + | It is the responsibility |
It is the responsibility of the facility to ensure that all users of the decimal3D have had training on the decimal3D App and possess the appropriate clinical education and experience to properly use the application. | It is the responsibility of the facility to ensure that all users of the decimal3D have had training on the decimal3D App and possess the appropriate clinical education and experience to properly use the application. | ||
Line 72: | Line 72: | ||
- Once a scan has been created its name cannot be edited (scan names are for convenience only and are used elsewhere in the application) | - Once a scan has been created its name cannot be edited (scan names are for convenience only and are used elsewhere in the application) | ||
- Once a beam has been created its name cannot be edited (beam names are used within the cutout engraving, therefore if an appropriate name was used, we recommend that you create a new beam with the desired name, using the same parameters, and then delete the wrongly named beam) | - Once a beam has been created its name cannot be edited (beam names are used within the cutout engraving, therefore if an appropriate name was used, we recommend that you create a new beam with the desired name, using the same parameters, and then delete the wrongly named beam) | ||
- | |||
- | [[decimal3d: | ||
===== Release Notes ===== | ===== Release Notes ===== | ||
decimal3d/instructions_for_use/instructions_for_use.txt · Last modified: 2023/04/17 16:34 by kerhart