decimal3d:instructions_for_use:instructions_for_use
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
decimal3d:instructions_for_use:instructions_for_use [2019/11/29 13:07] – [Coordinates and Units of Measure] kerhart | decimal3d:instructions_for_use:instructions_for_use [2019/11/29 13:13] – [Release Notes] kerhart | ||
---|---|---|---|
Line 61: | Line 61: | ||
==== System Calibration ==== | ==== System Calibration ==== | ||
- | The decimal3D application relies on both the Structure Sensor and built-in iPad color camera. Proper operation of the decimal3D App requires that these two components be properly calibrated to ensure accurate alignment of scanned image colorization. A calibrator app has been provided with your iPad and the system is shipped pre-calibrated. However, part of the regular maintenance of the decimal3D application is for users to verify and adjust the calibration every 6 months OR anytime the Structure | + | The decimal3D application relies on both the Structure Sensor |
===== Known Limitations ===== | ===== Known Limitations ===== | ||
Line 70: | Line 70: | ||
- User passwords cannot be changed within the decimal3D App (please log in to direct.dotdecimal.com to change your password or contact .decimal customer service to request a password reset) | - User passwords cannot be changed within the decimal3D App (please log in to direct.dotdecimal.com to change your password or contact .decimal customer service to request a password reset) | ||
- Patient Databases are stored locally on each iPad, so facilities with more than one iPad will not be able to access all patient records from each iPad (note: once an Order is place however, the order information is available via direct.dotdecimal.com, | - Patient Databases are stored locally on each iPad, so facilities with more than one iPad will not be able to access all patient records from each iPad (note: once an Order is place however, the order information is available via direct.dotdecimal.com, | ||
- | - Once a scan has been created its name cannot be edited (scan names are for convenience only and are used elsewhere | + | - Once a scan has been created its name cannot be edited (scan names are for convenience only and are used only for convenience |
- | - Once a beam has been created its name cannot be edited (beam names are used within | + | - Once a beam has been created its name cannot be edited (beam names are used as part of the cutout engraving |
===== Release Notes ===== | ===== Release Notes ===== | ||
- | For the release notes for each version of the Planning | + | For the release notes for each version of the decimal3D |
decimal3d/instructions_for_use/instructions_for_use.txt · Last modified: 2023/04/17 16:34 by kerhart