decimal3d:instructions_for_use:instructions_for_use
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| decimal3d:instructions_for_use:instructions_for_use [2019/11/29 13:13] – [Release Notes] kerhart | decimal3d:instructions_for_use:instructions_for_use [2020/01/27 16:14] – kerhart | ||
|---|---|---|---|
| Line 72: | Line 72: | ||
| - Once a scan has been created its name cannot be edited (scan names are for convenience only and are used only for convenience in the application) | - Once a scan has been created its name cannot be edited (scan names are for convenience only and are used only for convenience in the application) | ||
| - Once a beam has been created its name cannot be edited (beam names are used as part of the cutout engraving text, therefore if an appropriate name was used, we recommend that you create a new beam with the desired name, using the same parameters, and then delete the wrongly named beam) | - Once a beam has been created its name cannot be edited (beam names are used as part of the cutout engraving text, therefore if an appropriate name was used, we recommend that you create a new beam with the desired name, using the same parameters, and then delete the wrongly named beam) | ||
| + | |||
| ===== Release Notes ===== | ===== Release Notes ===== | ||
decimal3d/instructions_for_use/instructions_for_use.txt · Last modified: 2023/04/17 16:34 by kerhart