decimal3d:userguide:tutorials:all_tutorials
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| decimal3d:userguide:tutorials:all_tutorials [2021/06/17 13:40] – [Standard Blocks] dpatenaude | decimal3d:userguide:tutorials:all_tutorials [2021/06/17 16:32] – kerhart | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Application Features ====== | ====== Application Features ====== | ||
| - | ===== Beams ===== | + | ===== Standard Blocks |
| - | + | ||
| - | ==== Standard Blocks ==== | + | |
| decimal3D allows users to select and order a standard block from a predetermined library of shapes. Currently the library is compromised of: | decimal3D allows users to select and order a standard block from a predetermined library of shapes. Currently the library is compromised of: | ||
| * Circles | * Circles | ||
| - | * 1 to 23cm diameter in 0.5cm increments | + | * 1cm to 23cm diameter in 0.5cm increments |
| * Squares | * Squares | ||
| - | * 1 to 23cm diameter in 0.5cm increments | + | * 1cm to 23cm diameter in 0.5cm increments |
| When creating a beam users can choose to check their patient contour against the fit of the supported standard blocks. | When creating a beam users can choose to check their patient contour against the fit of the supported standard blocks. | ||
decimal3d/userguide/tutorials/all_tutorials.txt · Last modified: 2023/01/20 13:06 by dpatenaude