decimal3d:userguide:tutorials:all_tutorials
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
decimal3d:userguide:tutorials:all_tutorials [2021/06/17 16:32] – kerhart | decimal3d:userguide:tutorials:all_tutorials [2021/06/21 19:01] – kerhart | ||
---|---|---|---|
Line 9: | Line 9: | ||
* 1cm to 23cm diameter in 0.5cm increments | * 1cm to 23cm diameter in 0.5cm increments | ||
- | When creating a beam users can choose to check their patient contour against the fit of the supported standard blocks. | + | When creating a beam, users can choose to check their patient contour against the fit of the supported standard |
{{ : | {{ : | ||
- | The top 10 best fitting | + | The 10 best fitting standard blocks |
{{ : | {{ : | ||
- | When a standard block is selected for a beam the original patient contour | + | Users may select |
- | <WRAP center round info 60%> | + | <WRAP center round info 70%> |
**Note: | **Note: | ||
- | When editing a beam with a standard block the standard block will be automatically removed. | + | Standard blocks |
</ | </ | ||
decimal3d/userguide/tutorials/all_tutorials.txt · Last modified: 2023/01/20 13:06 by dpatenaude