Differences

This shows you the differences between two versions of the page.

--- decimal3d:userguide:tutorials:all_tutorials [2023/01/19 22:17] – [Troubleshooting DICOM Export Servers] kerhart
+++ decimal3d:userguide:tutorials:all_tutorials [2023/01/19 22:23] – [DICOM Export Servers] kerhart
@@ Line 46: / Line 46: @@
 </WRAP>
-Setting up a DICOM export server allows users to export an RT Plan with the design device. The following options are present in the DICOM Export Server settings:
+Setting up a DICOM export filter (sender) allows users to export an RT Plan with the design device. The following options are present in the DICOM Export settings:
   * **DICOM Receiver Hostname**: The IP address (e.g.: 192.168.12.7) or resolvable network hostname (e.g.: the server name) of the DICOM server intended to export to.
   * **DICOM Receiver Port**: The TCP/IP port of the DICOM monitoring/listening receiver (e.g.: 104)
@@ Line 55: / Line 55: @@
     * None: This will omit the applicator from the DICOM RT Plan during export.
-Below are the steps required to setup a DICOM Export Server:
+Below are the steps required to setup a DICOM Export Filter (sender):
-  - Obtain the IP Address and Port used for existing DICOM Receiver.
+  - Obtain the IP Address and Port used for the desired destination (DICOM Receiver).
-    -
+  - Enter the IP Address and Port in the decimal3D Advanced Settings page.
+  - Run the DICOM Receiver ECHO test on the Advanced Settings page.
+  - If successful, set up is complete and export is ready.
+  - If unsuccessful, refer to the troubleshooting items below for further guidance.
-**Note: the electron block present in the exported DICOM RT Plan file will not include any millability features (e.g.: the rounding of sharp corners to facilitate in fabrication) that decimal3D applied to your devices.**
+**Note: The electron block present in the exported DICOM RT Plan file will not include any millability features (e.g.: the rounding of sharp corners to facilitate in fabrication) that decimal3D applied to your devices.**
 === Troubleshooting DICOM Export Servers ===
@@ Line 80: / Line 83: @@
 This option allows the user to set whether they want to include the patient MRN in the order file's PO field that is set to .decimal. This option allows some centers to easily link an order placed to .decimal to the patient record based on the patient's MRN.
-**Note: The MRN is considered by some hospital's security teams to be Patient Identifying Information (PII). Please check with your hosptial's security team before enabling this option.**
+**Note: The MRN is considered by some hospital's security teams to be Patient Identifying Information (PII). Please check with your hosptial's security team before enabling this option and ensure a BAA is in place with our company.**