decimal App Documentation

User Tools

Site Tools

Trace:
decimal3d:userguide:tutorials:all_tutorials

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
decimal3d:userguide:tutorials:all_tutorials [2023/01/19 22:18] – [MRN to PO Field] kerhartdecimal3d:userguide:tutorials:all_tutorials [2023/01/19 22:23] – [DICOM Export Servers] kerhart
Line 46: Line 46:
 </WRAP> </WRAP>
  
-Setting up a DICOM export server allows users to export an RT Plan with the design device. The following options are present in the DICOM Export Server settings:+Setting up a DICOM export filter (sender) allows users to export an RT Plan with the design device. The following options are present in the DICOM Export settings:
   * **DICOM Receiver Hostname**: The IP address (e.g.: 192.168.12.7) or resolvable network hostname (e.g.: the server name) of the DICOM server intended to export to.   * **DICOM Receiver Hostname**: The IP address (e.g.: 192.168.12.7) or resolvable network hostname (e.g.: the server name) of the DICOM server intended to export to.
   * **DICOM Receiver Port**: The TCP/IP port of the DICOM monitoring/listening receiver (e.g.: 104)   * **DICOM Receiver Port**: The TCP/IP port of the DICOM monitoring/listening receiver (e.g.: 104)
Line 55: Line 55:
     * None: This will omit the applicator from the DICOM RT Plan during export.     * None: This will omit the applicator from the DICOM RT Plan during export.
  
-Below are the steps required to setup a DICOM Export Server: +Below are the steps required to setup a DICOM Export Filter (sender): 
-  - Obtain the IP Address and Port used for existing DICOM Receiver. +  - Obtain the IP Address and Port used for the desired destination (DICOM Receiver). 
-    - +  - Enter the IP Address and Port in the decimal3D Advanced Settings page. 
 +  - Run the DICOM Receiver ECHO test on the Advanced Settings page. 
 +  - If successful, set up is complete and export is ready. 
 +  - If unsuccessful, refer to the troubleshooting items below for further guidance.
  
  
-**Note: the electron block present in the exported DICOM RT Plan file will not include any millability features (e.g.: the rounding of sharp corners to facilitate in fabrication) that decimal3D applied to your devices.**+**Note: The electron block present in the exported DICOM RT Plan file will not include any millability features (e.g.: the rounding of sharp corners to facilitate in fabrication) that decimal3D applied to your devices.**
  
 === Troubleshooting DICOM Export Servers === === Troubleshooting DICOM Export Servers ===
decimal3d/userguide/tutorials/all_tutorials.txt · Last modified: 2023/01/20 13:06 by dpatenaude