decimal3d:userguide:tutorials:all_tutorials
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
decimal3d:userguide:tutorials:all_tutorials [2023/01/19 22:18] – [MRN to PO Field] kerhart | decimal3d:userguide:tutorials:all_tutorials [2023/01/19 22:23] – [Software Settings] kerhart | ||
---|---|---|---|
Line 31: | Line 31: | ||
The decimal3D Software Settings allow the user to configure the following items: | The decimal3D Software Settings allow the user to configure the following items: | ||
- | * [[decimal3d: | + | * [[decimal3d: |
* [[decimal3d: | * [[decimal3d: | ||
* [[decimal3d: | * [[decimal3d: | ||
Line 38: | Line 38: | ||
- | ==== DICOM Export | + | ==== DICOM Export ==== |
<WRAP center round important 60%> | <WRAP center round important 60%> | ||
Line 46: | Line 46: | ||
</ | </ | ||
- | Setting up a DICOM export | + | Setting up a DICOM export |
* **DICOM Receiver Hostname**: The IP address (e.g.: 192.168.12.7) or resolvable network hostname (e.g.: the server name) of the DICOM server intended to export to. | * **DICOM Receiver Hostname**: The IP address (e.g.: 192.168.12.7) or resolvable network hostname (e.g.: the server name) of the DICOM server intended to export to. | ||
* **DICOM Receiver Port**: The TCP/IP port of the DICOM monitoring/ | * **DICOM Receiver Port**: The TCP/IP port of the DICOM monitoring/ | ||
Line 55: | Line 55: | ||
* None: This will omit the applicator from the DICOM RT Plan during export. | * None: This will omit the applicator from the DICOM RT Plan during export. | ||
- | Below are the steps required to setup a DICOM Export | + | Below are the steps required to setup a DICOM Export |
- | - Obtain the IP Address and Port used for existing | + | - Obtain the IP Address and Port used for the desired destination (DICOM Receiver). |
- | - | + | - Enter the IP Address and Port in the decimal3D Advanced Settings page. |
+ | - Run the DICOM Receiver ECHO test on the Advanced Settings page. | ||
+ | - If successful, set up is complete and export is ready. | ||
+ | - If unsuccessful, | ||
- | **Note: | + | **Note: |
=== Troubleshooting DICOM Export Servers === | === Troubleshooting DICOM Export Servers === |
decimal3d/userguide/tutorials/all_tutorials.txt · Last modified: 2023/01/20 13:06 by dpatenaude