Differences

This shows you the differences between two versions of the page.

--- dosimetry:userguide:design_task_functions:dtf [2016/04/05 20:14] – [Aperture Mill Radius and Smoothing] anegron
+++ dosimetry:userguide:design_task_functions:dtf [2021/07/29 18:28] (current) – external edit 127.0.0.1
@@ Line 23: / Line 23: @@
     * Builds an aperture using the given point list.
     * Recommended mill radius value is is 4.7625mm (0.1875") and advised to be no less than 2.38125mm (0.09375") to allow for accurate machining.
+  * **remove_polyset_holes:**
+    * A polyset's holes defined an aperture's floating islands. By removing the polyset holes, the resulting computed aperture will contain no islands.
+    * This function removes the holes from a polyset of an existing aperture (e.g.: Call compute_aperture() and using the polyset from the returned aperture call remove_polyset_holes(). Then replace the original aperture polyset with the polyset returned from remove_polyset_holes())
+  * **apply_mill_radius:**
+    * This function applies a machinability enforcement using a tool mill radius to a polyset of an existing aperture. The resulting polyset shape will not have corners that produce machined under cutting for the mill radius defined.
 ==== Geometry ====
@@ Line 137: / Line 142: @@
 <WRAP center 50%>
 <imgcaption ap_beam_setup|Source (Red), Beam (Green), Aperture Plane (Gold), and Target (Blue)>{{ dosimetry:userguide:design_task_functions:aperture_beam_setup.png?nolink&450 |}}</imgcaption>
-<imgcaption ap_smoothalgorithm|Smoothing algorithm>{{dosimetry:userguide:design_task_functions:new_smoothing.png?nolink&500|}}</imgcaption>
+<imgcaption ap_smoothalgorithm|Method of smoothing>{{dosimetry:userguide:design_task_functions:new_smoothing.png?nolink&500|}}</imgcaption>
 </WRAP>