Differences

This shows you the differences between two versions of the page.

--- planning:userguide:tutorials:apertures [2017/08/03 16:20] – [Manual Edits] dpatenaude
+++ planning:userguide:tutorials:apertures [2021/07/29 18:28] (current) – external edit 127.0.0.1
@@ Line 5: / Line 5: @@
 ===== Adding an Aperture =====
-  * From within the PBS Beam Task you may add an aperture to a beam by clicking the "Add One" button from within the //Aperture Task Block// . {{ :planning:userguide:tutorials:aperture_add.png?250 |}}
+==== PBS ====
+  * From within the PBS Beam Task you may add an aperture to a beam by clicking the "Add One" button from within the //Aperture Task Block//. {{ :planning:userguide:tutorials:aperture_add.png?250 |}}
+==== SOBP ====
+  * From within the SOBP Beam Task, an initial aperture is automatically created (note: the "Create New Hardware" option is selected from within the //Aperture Task Block//) based on your site configuration default margins and the selected beam target. Changes to the default aperture can be made according to the instructions and descriptions below if needed. Alternatively, you can re-use an existing aperture by clicking the "Re-Use Existing Hardware" button. Selecting the "Re-Use Existing Hardware" option ensures that the current beam will use the exact same device used in an another beam within the plan. {{ :planning:userguide:tutorials:re-using_existing_hardware_-_aperture.png? 300 |}}
 ===== Target =====